Gardsman CTC-1132, Инструкция по установке и эксплуатации

Страница: 35 / 48

31
The defined EXIT Delay is displayed on the
second line, and is counting down. During the
EXIT Delay period, the exit sound plays, unless
it has been chosen to switch off.
Step 4. When the Exit Delay time is up, the
Control Panel will sound a long beep.
The
Home will display on the screen
and the system is in Home Arm mode.
< < N N O O T T E E > >
)
The system can also be armed by
using the Remote controller (Optional).
Step 5. Press OK key and the screen will
display.
H o m e
0 8 : 0 0 1 6 D e c
3.5.2. Stopping the Exit Delay
The Exit Delay can be stopped following the
steps described in
Stopping the Exit Delay in
section 3.2. Away Mode
3.5.3. Extend the Exit Delay
The Exit Delay can be extended following the
steps described in
Extend the Exit Delay in
section 3.2. Away Mode
3.5.4. Forced Arming
z If there is any fault condition has occurred
or a door was found opened before or any
sensor is triggered, when you press
OK in
step 3 above or when you press Home
button on the Remote Controller, the
Control Panel will sound a ding-dong
warning sound to indicate entering the
Home mode is prohibited. You rectify the
problem first, then clear the fault display,
and then try again. Or you can do forced
arming to enter Home mode compulsorily.
Please follow the instructions described in
Forced Arming in Section 3.3.
3.6. Partial (By-pass) Arm
Mode
The Partial (By-pass) Arm mode allows the
user to de-activate (by-pass) any sensors at
their discretion. This feature allows your home
to be armed; yet the person inside the house
can move freely in the area where the sensor
is by-passed.
To put the system into the Partial (By-
pass) Arm mode:
Step 1. Enter your PIN code and press OK key
within 10 seconds. The display will
show
:
A w a y A r m
H o m e A r m
B y p a s s
Step 2. Press T key to move the cursor down
to select Bypass .
Step 3. Press OK key
Step 4. All the zones are listed in zone number
order.
D C B a c k d o o r
I R H a l l w a y
D C F r o n t d o o r
I R L i v i n g r o o m
R C M R . S M I T H
S t o p
Step 5. Press T & S keys to select the zone to
be by-passed.
B y - p a s s : ( O k ? )
D C B a c k d
o o r
Step 6. Press OK key to confirm the selection.
The selected zone will be marked with
a
¿
character in front of it to indicate
that device is to be by-passed.
< < N N O O T T E E > >
)
The zones can be toggled between
by-passed and not by-passed by
pressing the
OK key repeatedly
followed by the
¿
character appearing
for By-pass setting and
¿
character
disappearing for By-pass unsetting.
Step 7. You can repeat Step 5 ~ Step 6 to
continue selecting the device to be by-
passed.