Gardsman CTC-1132, Инструкция по установке и эксплуатации

Страница: 32 / 48

28
3. Operation
3.1. Entering User Menu
When the system is in Disarmed mode (Alarm
off), entering a valid user code can access the
user menu, the system can then be Away
armed or Bypass armed via this menu.
When the first numberic key is pressed, the
display will show:
E n t e r C o d e
¿
. . .
when the complete PIN code is keyed in
followed by
OK key, within 10 sec., the first two
li
nes of the user menu is shown:
A w a y A r m
H o m e A r m
A flashing dot will appear next to Away Arm ,
the complete menu list consists of:
A w a y A r m
H o m e A r m
B
y p a s s
L o g
C o n t r o l P S S
These items can be scrolled through by using
the
T & S keys.
< < N N O O T T E E > >
)
If there is any fault event occurred, no
matter if the fault condition has been
rectified or not, when you enter the
PIN Code followed by
OK , the
following screen will be displayed.
F a u l t D s p
A w a y A r m
H o m e A r m
B
y p a s s
L o g
C o n t r o l P S S
And the cursor stays at Fault Dsp
position. To arm the system, please
see the section
Forced Arming
below.
)
If there is any SMS message saved,
the screen will display SMS for SMS
message reading.
)
If you press key while the Alarm
off is displayed, a Enter Code promp
screen will be displayed. After you
enter your pin Code, the above screen
will also be displayed.
)
After 30 seconds of key-inactivity, the
system will automatically exit User
Menu and return to
Alarm off mode.
3.2. Away (Alarm ON) Mode
3.2.1. Arming the system
If the system is in Disarmed mode (Alarm off),
to arm the system.
Step 1. Enter your PIN code and press OK key.
The display will show :
A w a y A r m
H o m e A r m
B y p a s s
L o g
and the cursor stays at Away Arm
Step 2. Press OK key and the screen will
display.
T i m e T o E x i t
3 0 s e c
The defined EXIT Delay is displayed on the
second line, and is counting down. During the
EXIT Delay period, the exit sound plays, unless
it has been chosen to switch off.
Step 3. When the Exit Delay time is up, or the
Entry Door Contact (Final Door Set
Function programmed to be On ) is
closed, the Control Panel will sound a
long beep. The
Alarm On will display
on the screen and the system is in
Arm mode.
A l a r m O N
0 7 : 2 5 1 6 D e c
<
<
N
N
O
O
T
T
E
E
>
>
)
When Final Door Set Option is set to
Off , the Control Panel enters Alarm
On mode only when the Exit Delay
time is up.