Gardsman CTC-1132, Инструкция по установке и эксплуатации, Страница: 27 / 48

23
2.5.3. Remove Devices
Adding a device a second time is prohibited
unless it is removed from the system first. To
delete a device, choose
Remove Device in the
/- menu
Step 1. Use S & T keys to scroll the display.
All the used zones with the device
names are listed in order of the zone
numbers.
D C B a c k d o o r
I R
H a l l w a y
R C M R . S M I T H
S
D K i t c h e n
Step 2. Press OK key when the required
device is chosen. The following
prompt message will be displayed for
you to reconfirm.
R e m o v e : ( O k ? )
R C M R . S M I T H
Step 3. Press OK key. Deleting a device is
now completed. The screen returns to
previous device list.
<
<
N
N
O
O
T
T
E
E
>
>
)
If the selected sensor/zone is not what
you want to delete, press
key to exit,
the device list is again displayed for
you to make another selection.
)
If Remove Device menu is chosen
while no device has been installed,
the display will show
No device
found in system for 2 sec. and return
to the /- menu.
Step4. Proceed to remove other devices or
Press key to return to Add/Delete
Device menu.
2.5.4. Program Siren
If an outdoor Bell Box, Indoor Bell Box or
Universal Receiver etc. is to be included in the
system, it should be programmed first by the
Control Panel, so that the Control Panel can
communicate with these auxiliary devices.
Before adding these auxilary devices, any least
one other type of device must be learnt-in
already (e.g. a Door Contact or PIR, but not
Siren, Bell Box, or PSS).
To program these auxiliary devices, select
Program Siren in the /- menu.
Choose Learn Siren , then press OK .
L e a r n S i r e n
S i r e n T a m p . O n
S i r e n T a m p . O f
C o n f i r m O n
C o n f i r m O
f f
E n t r y S n d O n
E n t r y S n d O f f
R e c e i v e r 1
R e c e i v e r 2
Learn Siren
If there is any detector or Remote
Controller has been added already,
Step 1 . Put all the desired Auxiliary devices
into learn mode (Refer to their
individual Operational Manual).
Step 2 . Move the cursor to the position Learn
Siren .
Step 3 . Press OK key.
Step 4 . The Control Panel will then sound a
long beep and transmit Learning code
to all devices simultaneously. The Out
Door Bell Box (BX-8) should respond
by activating its siren & strobe light
momentarily while the UR-7 status
LED lights up for 3 seconds.
Step 5 . Place these auxiliary devices out of
Learn mode. Adding them into the
system is completed.
< < N N O O T T E E > >
)
If any of these devices does not
respond, make sure that the device is
in learn mode and repeat the steps
again.
)
After they are added in, every time
pressing a PIN code & followed by
OK
key will result in the Control Panel
transmitting signal to all of them
)
If there is no other detector or Remote
Controller being added first, the
following message will be displayed in
Step 3.