37-1-615 Page 45
NOTE:
It is recommended to apply a thin coat of Dow Corning 736 sealant on each side of gaskets
(58, 24) prior to installation.
The third important measurement for clearance is to provide for floating bearings at the gear
end.
22. Turn the unit end for end, gear end up. With a depth micrometer on a perfectly flat parallel bar
across the bearing bore, measure the distance to the shoulder in the bearing bore,
FIGURE 7-21.
FIGURE 7-20
Содержание 9CDL R Series
Страница 13: ...37 1 615 Page 12 FIGURE 2 3 BELT DRIVE OVERHUNG LOAD CALCULATIONS...
Страница 16: ...37 1 615 Page 15 9CDL SERIES TOP INLET MAIN ROTOR DRIVE FIGURE 2 4 OUTLINE DIMENSIONS...
Страница 30: ...37 1 615 Page 29 SECTION 5 PARTS LIST FOR LIST OF PARTS SEE PAGES 32 33 303CBP810 00 Ref Drawing...
