GARDEO PRO GPTDE1843-2L, Оригинальное руководство пользователя

Страница: 41 / 64

41
On slopes mow across the slope (not in up or down
direction).You can counteract the tendency of the
mower to slide down the slope by setting it at an
angle upwards.
that you do not remove more than 4 cm of grass
length in any one pass.
Switch off the motor before you carry out any
inspections of the blade. Remember than the
blade will continue to turn for a few seconds after
the motor has been switched off. Never
attempt to stop the blade.
Check regularly that the blade is correctly secured,
in good condition and well ground. If not,
grind or replace the blade. If the moving blade
strikes an object, stop the mower and wait until
the blade has come to a complete standstill. Then
check the condition of the blade and the
blade holder. If they are damaged, they must be
replaced.
Place the mains lead in loops on the ground in front
of the socket. Mow away from the socket
and cable and ensure that the mains lead is always
on the section of lawn that you have already mowed
so that you do not run over the mains lead with the
mower. As soon as you see mown grass on the
lawn whilst you are mowing, the grass bag will need
emptying.
> Mulching
Your lawn mower can also be used for mulching.
To do so, install the mulching wedge :
▪
Raise the rear cover and remove the grass box.
▪
Push the mulching wedge into the deck. Lock it
tightly in its position.
▪
Lower the rear cover again.
> Gras box warning system
There is a warning piece in the grass box which will
indicate the grass volume.
▪
If the flap is open it means that there is still
space for grass collection.
▪
If the flap is closed it means that there is no
space for grass collection.
CLEANING AND MAINTENANCE
Attention!
Before performing any work
on the equipment, pull out
the power plug.
> Cleaning
§ Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with
compressed air at low pressure.
§ We recommend that you clean the device
immediately each time you have finished using it.
§ Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the
device.
Never use solvents such as
petrol, alcohol, ammonia
water, etc. These solvents
may damage the plastic
parts.
> Blade maintenance
§ Regularly remove grass and dirt from the blade.
§ At the beginning of the gardening season,
carefully examine the condition of the blade.
§ If the blade is very blunt, sharpen or replace the
blade.
§ If the blade is damaged or worn, fit a new blade.
Warning!
Observe the following
precautions:
§ Disconnect the mower from the mains and wait
until the blade has stopped rotating before
proceeding.
§ Be careful not to cut yourself. Use heavy-duty
gloves or a cloth to grip the blade.
§ Only use the specified replacement blade.
§ Do not remove the impeller (A)for any reason.
> Replacing the blade
«
Fig E »
For safety reasons, we recommend having the
blade replaced by an authorized professional.
Important: Wear work gloves!
Replacement blade, as this will ensure top
performance and safety under all conditions. Carry
out the following steps to change the blade:
§ Turn the mower onto its side.
§ Grip the blade( C) with one hand.
§ Use a wrench (not supplied) to loosen and remove
the blade nut (B).
§ Replace the blade
§ Securely tighten the blade nut.