S
U
A
1800 909 909
www.powertoolsupport.com email: [email protected]
AFTER SALES SUPPORT
46460
14
5. Place the chain (2) around the drive sprocket wheel (23) with the chain links in the
direction shown on the bar and fit the chain around the guide bar. (Fig H&I)
6. Replace the chain drive cover on to the chainsaw and hold the cover on to the
chain bar. DO NOT SECURE WITH THE NUT. (Fig J)
7. Fit the securing nut and tighten FINGER TIGHT. Check again the cover is flat on the
surface of the bar. (Fig K)
8. While holding the cover on firmly, grasp the chain bar and slide the bar outward
slowly. When the chain tensioning pin aligns with the clearance hole in the bar,
the cover will drop firmly and flat on the bar. If the chain tensioning pin does not
align, adjust the tension screw so the pin aligns with the hole in the bar. The pin
must enter the bar before the nut is applied. (Fig L)
9. Tighten the chain tensioner screw (3) until the links of the chain just touch the
bottom edge of the guide bar. (Fig M)
11. Tighten the rear side cover locking knob firmly. (Fig N)
12. Tighten the chain drive side cover nut firmly. (Fig O)
Note.
Ensure the engine is switched off when making any adjustments to the
chain and bar.
Getting Started
4
H
L
I
M
J
N
K
O