S
U
A
1800 909 909
www.globalpowerbrands.com email: [email protected]
AFTER SALES SUPPORT
43670
19
Advancing the line manually
1. Push the bump knob in while pulling on both lines to manually advance the line.
2. Release the bump knob and again pull on both lines to advance the line further.
3. If the line still does not advance remove the spool and check the lay of the line.
It may be twisted or trapped under over laying line.
Tips for cutting
WARNING.
Beware of bystanders at all times
• Cut the grass like you are in a corridor about 1.5m wide. Move step by step,
moving the machine from left to right and vice-versa. Make sure at each step
that you are still well balanced on your feet
• Keep the line trimmer tilted towards the area being cut
• Let the tip of the line do the cutting. Never force the spool into uncut grass.
• Running the line into fences, stone and brick walls, curbs, and wood causes
extra line wear, even breakage.
Replacement of the cutting line
1. Stop the engine.
2. Put the petrol line trimmer on the floor in a way that the cutting line and spool
assembly (1) is facing up.
3. Open the cutting line and spool assembly (1) by holding the spool housing
firmly while rotating the bump knob anti-clockwise.
4. Remove the bump knob completely and remove the spool from the spool shaft.
Discard any short lengths of remaining cutting line.
5. Take a 4 metre length of Ø2mm line and halve it.
6. Place the half way mark of the line into the notch in the spool.
7. Wrap the line around the inside of the spool in an anti
clockwise direction (following the directional arrows on the
spool). Ensure the line is wrapped tightly and neatly.
8. When there is approximately 150mm of line left, lock one of
the lines into one of the line location notches in the spool head
and the other into the opposing notch.
5
Instructions
