S
U
A
1800 909 909
www.globalpowerbrands.com email: [email protected]
AFTER SALES SUPPORT
43670
11
2. Place the hex nut into the hex shape recess
on the guard. Slide the screw through the
side of the safety guard and tighten with
the hex key provided.
Joining the shaft
1. Depress the location pin and insert the
lower shaft (5b) into the upper shaft (5a).
Rotate the lower shaft until the pin locates
positively into the hole in the upper shaft.
2. Tighten the shaft locking knob (21) to
secure both shafts in place.
Fitting the spool
Note.
The spool assembly is contained
with shrink plastic to assist in the assembly.
Keep this plastic wrap intact while you assemble. When fitting
the spool on the shaft, the shaft will pierce through the thin
plastic wrap.
1. Slide the raised section of the spool (1) onto the end of the
shaft. Ensure the large hex recess on the rear of the spool fits
fully over the large hex drive on the base of the spindle.
2. With your fingers, push the spool fully into the housing and
screw the bump knob (18) onto the end of the shaft by turning
it in a clockwise direction. Screw the bump knob onto the
shaft until it’s tight whilst holding the spool.
Note.
Ensure to remove any packing tape and plastic wrap
from the spool at this stage.
3. Once the spool is fully inserted and the lines are fully through
the eyelets, pull firmly on each line to disengage the lines from the spool notches.
Ensure the lines are fully clear of the spool notches and the line is passing through
the eyelets directly to the spool.
Note.
If you require replacement spool and line, this is available for purchase.
Please refer to page 23 for further detail.
5
Instructions
