S
U
A
1800 909 909
www.globalpowerbrands.com email: [email protected]
AFTER SALES SUPPORT
43671
14
Starting A Cold Engine
CAUTION.
Ensure the blade cover is removed before
attempting to start the hedge trimmer.
Note.
Ensure the hedge trimmer has been filled with the
relevant fuel:oil 40:1 mixture before proceeding with
operation of the hedge trimmer.
1. Place the hedge trimmer on a firm flat surface.
2. Move the ignition switch to the run position marked
with a “I”. (Fig 1)
3. Your unit is designed with a 2 position choke:
Full Choke
and
No Choke.
Move the red choke lever (14) to the Full Choke position (Fig 2).
4. Prime the carburettor. Pump the prime bulb
(13) 6 times (Fig 3).
5. Set the throttle trigger to the “START POSITION”. Grip the
rear handle (12) of the hedge trimmer and at the same
time pressing down the safety lever (5). Squeeze FULLY
the throttle Trigger (6) and hold in the full on position.
Depress the Throttle Start Button (16) on the side of the
handle. Whilst holding the button (16) depressed. Slowly
release the throttle trigger (6). The throttle trigger will
engage on the throttle start button, locking the throttle
trigger in a part on condition.
The throttle trigger, the Safety lever and the throttle
starting button can now be released.
6. Pull the recoil starter out a short way until resistance is
felt (approximately pull: 4”) (Fig 4a). A smooth rapid
pull is required for a strong spark.
Pull the recoil starter briskly 4 times.
5
Operating Instructions
Fig. 1
Fig. 4a
Fig. 3
Fig. 4
5
16
6
Fig. 2
