![background image](http://html1.mh-extra.com/html/gardenline/43671-htks26/43671-htks26_user-manual_3543963015.webp)
S
U
A
1800 909 909
www.globalpowerbrands.com email: [email protected]
AFTER SALES SUPPORT
43671
15
Operating Instructions
5
7. Once the engine starts allow to run for 10 seconds.
Note.
If the engine starts at all and then stops, even for 1 sec,
move the choke lever to the mid way position between the full
choke and no choke position and pull the recoiler to re start.
WARNING.
On start up the oscillating blades may be
operational due to the setting of the starting throttle. Be well
aware of this condition
8. Move the red choke lever (14) to the no choke position
(Fig 4b) and allow to run for a further 10 sec.
9. After the motor is operating and partly warmed after point 8 above, Grip the
rear handle (12) of the hedge trimmer and at the same time pressing down the
safety lever (5). Squeeze slightly the throttle Trigger (6) and then release the trigger.
This will disengage the starting trigger lock and allow the motor to idle correctly and
disengaging the oscillating blades.
10. If the engine fails to start, repeat steps 1 through 8.
WARNING.
On start up the oscillating blades may be operational due to the
setting of the starting throttle. Be well aware of this condition.
Note.
If the engine fails to start after repeated attempts,
refer to Troubleshooting section.
Note.
Always pull the starter cord straight out. Pulling the starter cord at an
angle will cause it to rub against the eyelet. This friction will cause the cord to
fray and wear more quickly. Do not pull the end of the cord, this can damage the
starter. Always hold the starter handle when the cord retracts. Never allow the
cord to snap back from the extended position. This could cause the cord to snag or
fray and also damage the starter assembly.
Fig. 4b