Mark the motor mount location at the bottom of the mast and loosen the motor bolts.
elease the tension on the belt by loosening the moun
otor assembly.
ake the belt off the pulley on the screw. You can remove the belt if you wish to replace
. Otherwise, leave it in place.
bly screws. There
emove the lower nuts on the screw.
ift the screw up until it clears the carriage at the bottom and then extract it out the front
f the mast.
In units 96” and greater, the stabilizer system must be removed with the screw. Once
the screw is removed, the stabilizer may be detached.
R
ting bolts for the m
T
it
Remove the lower Screw nut and loosen the bottom bearing assem
may be two of them in the collar of the bearing.
R
L
o
ITEM #05751 Revision B
Garaventa Lift, April 2008
14
