15
8-11. INSTALL WALL CONTROL PANEL
4
3
To Terminal #4 Screw
To Terminal #3 Screw
Screw caps
Fig. 25
The control panel must be mounted inside the garage within sight of the
garage door, clear of all moving garage door parts or any associated parts
- and at least 5 feet above the floor to prevent the use of these controls by
children. The device should only be used when the door is in clear sight of
the user and the door area is free of people or any obstructions.
• Attach 2-conductor wire to the screw terminal on back of control panel
(see Fig. 25 (Back)). White wire attaches to terminal #3 screw, white
wire with color stripes attaches to terminal #4 screw.
• Position wall control panel onto wall in desired location.
• Mark hole location on wall.
• Drill 1/16” pilot holes into wall.
• Insert and tighten screws to secure control panel to wall.
• Make sure wiring is routed out from behind control through one of the
cutouts to avoid pinching the wires.
If mounting to drywall instead of wood, drill 3/16” pilot holes and use
anchors provided.
If mounting to electrical box that is prewired for this purpose, mount
directly to box with proper screws provided .
24V
Common (Ground)
Relay
T
R
Wall Control
Photo Eye
Fig. 26
To Terminal 1
To Terminal 2
To Terminal 4
To Terminal 3
Fig. 26A
8-12. CONNECTING WIRES TO OPERATOR
• Run wires from wall control panel and photo eye system along wall and
ceiling to operator powerhead. Use the staples to secure wiring to wall,
joists and ceiling. Do not pinch wiring. Drive staples with only enough
force to hold wiring in place. Refer to Fig. 8 on p.7 for an example of
typical wiring routing, and Fig. 26 for terminal assignment.
NOTE:
As an alternative for photo eye system, the wiring can be routed
along the top of the rail, or along the outside of the door track. Be sure the
wiring is routed away from all moving parts of the door and rail.
• Separate 2” of double wire from each photo eye sensor into two single
wires. Strip about 1/2” of insulation from the end of each of the four
single wires. Combine the white wires from each sensor and twist
stripped ends together tightly. Do the same with color striped wires.
• Open the control panel by slightly pulling on the panel cover tabs.
• Feed wall control and photo eye system wires through wire guide from the
top of the chassis into terminal area of control panel.
• Firmly insert white wire combination into terminal hole #1 by pushing
directly into hole. Insert color striped wire combination into terminal #2.
NOTE:
If wires are difficult to insert, a screwdriver may be used to depress
the terminal “tab” while inserting the wires. To remove wires, depress tab
again and pull wires out.
• Insert white single wire from wall control into terminal #3 and single color
striped wire into terminal #4.
NOTE:
Multiple wall controls may be installed in parallel with wires
connected to terminals #3 and #4.
• Detach right side panel from one of the wall controls (see Fig.25).
• Attach wiring to back of both wall controls (White wires to terminal #3
screws, wires with stripes to terminal #4 screws.)
• Follow the same steps as above to mount additional wall control panels
and wire connections.
Содержание CarGO 500
Страница 1: ......
