Ganz ZC-PT336N-IR, Руководство пользователя

Страница: 36 / 39

C. Protocal
The 4th, 5th of DIP SW2 above are used for protocol setting.
•
Factory default : Pelco-D or Pelco-P (Auto detection)
D. Baud Rate Setting
DIP SW2 - 4th, 5th
DIP SW2 - 4th DIP SW2 - 5th BAUD RATE
OFF ON Pelco-D or Pelco-P
OFF OFF Not used
ON ON Not used
ON OFF Not used
The 7th, 8th SW of DIP SW2 above a used for BAUD RATE setting. DIP SW can be
changeable to 4,800bps, 9,600bps.
•
Factory default : 2,400bps
DIP SW2 - 1st DIP SW2 - 2nd BAUD RATE
OFF OFF 2,400bps
ON OFF 4,800bps
OFF ON 9,600bps
ON ON Not used
•
The 3th, 6th, 7th of DIP SW2 are not used.
Trouble Shooting
If you have trouble setting up or operating the camera, refer to the following.
Problem Solution
NO OPERATION
•
Check if the power supply is AC 24V.
•
Check if RS-485 communication cable is connected correctly.
•
Check camera ID setting.
•
Check the termination.
NO PICTURE
•
Check if all the cables are connected correctly.
•
Check the monitor is adjusted correctly.
•
Check if video signal line is cut.
DARK SCREEN
•
Adjust the monitor status.
ABNOMAL CAMERA
OPERATION STATUS
•
Check if the voltage level is out of the specification.
•
Check the termination.
SCREEN NOT CLEAR
•
Check if there is dust on a lens.
•
Adjust the monitor status.
•
If excessive light is seen on a screen, change the camera angle or location.
•
Adjust the lens focus again.