G&J Hall POWERBOR PB32, Инструкция по эксплуатации

Страница: 14 / 26

14
PB32 - Revised 120810
MAGNET CONTROL PB32 COMBI
The PB32 Combi Magnet Control switch (I) is positioned at
the top of the PB32 Combi control panel.
„O‟ indicates magnet OFF „I‟ indicates magnet ON.
Ensure the magnet switch is OFF and the FWD/REV
switch is in the OFF position before connecting the power
supply.
Ensure the magnet is clean and free from debris and that
the machine is on a flat clean ferrous surface of the
required minimum thickness (10mm).
To switch the magnet ON, press the switch to the „I‟
position.
The security of the magnet should always be physically
checked BEFORE starting the drill unit.
I
J
K
K
OFF
FWD
REV
MOTOR CONTROL PB32 COMBI FWD/REV
The PB32 Combi drill unit or “motor” is controlled by a three position rotary switch (K) at
the bottom of the PB32 Combi control panel.
The motor or FWD / OFF / REV switch should be in the OFF position before connecting
the power supply to the machine.
The magnet switch should be in the ON position and the security of the magnet should
always be physically checked BEFORE the spindle is started.
To start the spindle in its normal rotation the three position selector switch should be in
the FWD position.
To start the spindle in the opposite rotation the three position selector switch should be in
the REV position.
The FWD / OFF / REV switch should NEVER be switched from FWD to REV or REV to
FWD without waiting until the motor has stopped rotating. Failure to follow this instruction
will result in damage to either the motor or switchgear.
The motor speed control on the PB32 Combi is intended mainly for tapping operations.
For normal use with an annular cutter the speed should be set to maximum to allow
maximum power.
The motor speed control knob (K) allows speed to be reduced by turning counter
clockwise and increased by turning clockwise.
Reducing the speed significantly will reduce the power/torque available.
MOTOR SPEED CONTROL PB32 COMBI