G&J Hall POWERBOR PB32, Инструкция по эксплуатации

Страница: 11 / 26

11
PB32 - Revised 120810
MOUNTING CUTTERS INTO THE ARBOR
The holder for the cutting tool is known as the
arbor. The arbor is designed to accept
Powerbor 3/4” Weldon shank annular cutters.
The Powerbor annular cutters normally have
two flats disposed at 90°to each other.
To mount the cutter.
First ensure the ejector pin is in place.
Align the two flats with the two fixing screws.
Push the cutter up into the arbor until it stops.
Tighten the two fixing screws onto the cutter
flats with the hex keys supplied.
FITTING THE DRILL CHUCK SUPPLIED
To replace the arbor (A) with the drill chuck
supplied first remove the arbor.
To do this, using the spanners supplied, place
one spanner on the flats of the drill output
shaft.
Turn clockwise (as viewed from above) until
the spanner meets the dovetail slide.
Place the the second spanner on the flats of
the arbor, apply pressure, again clockwise as
viewed from above.
If possible the magnet can be used to hold
the machine whilst removing the arbor.
If the arbor is tight the spanner on the arbor
flats can be tapped with a soft mallet.
Once the arbor is unscrewed the arbor
support bracket (B) needs to be removed.
This is accomplished by removing the two
hexagon socket head cap screws.
To fit the drill chuck simply screw it into place
on the spindle nose.
A special left handed screw is provided to
hold the chuck if the spindle rotation is
reversed (PB32 Combi only)
Replacement of the arbor is a reversal of the
procedure above.
TO REMOVE ARBOR
A
B