STRONG. SIMPLE. COMPACT.
Rev Date 23 0610
800.285.6780 [email protected]
EDGE
INSTALLATION MANUAL PAGE 4
Mounting the
EDGE
Fixtures
• EDGE
series wet location fixtures are typically surface mounted (Walls, Soffits, etc.). If mounting to the
building soffits, it is recommended to mount the fixtures on the outer edges of the soffits to maximize
the distance from the building walls. Fixtures should be aimed downward and slightly inward toward the
building for the best effect.
•
Each fixture has an input (male) and output (female) end. The end of the fixture with the product
identification label is the input end. The fixture must be installed with the input end oriented in the
direction of your incoming power source or leader cable.
•
The location of the fixtures must follow your site-specific layout.
•
For long linear runs, G&G recommends using a chalk line or laser to mark the mounting bracket locations.
•
2’, 4’, and 6’ fixtures require at least two mounting brackets. Brackets should be installed near the ends of
the fixtures. 8’ models require three brackets with the third bracket being installed near the center of the
light fixture.
•
This product makes use of a push-click connector system. An audible click upon insertion of the connector
indicates that the connector is fully seated. Failure to fully seat connectors can lead to cable and fixture
damage during use.
Connect the power leader cable to
the input connector (male) on the LED
fixture. To do this, align the connectors,
push inward, and listen for the audible
click sound that indicates that the
connector is fully seated.
When daisy chaining fixtures continue mounting fixtures and
attach jumper cables as needed using the same push-click
connection method as the leader cable.
Mount the fixture(s) in their specific location using the Surface Mount Bracket to affix directly to the ceiling or soffits.
