STRONG. SIMPLE. COMPACT.
Rev Date 23 0610
800.285.6780 [email protected]
EDGE
INSTALLATION MANUAL PAGE 8
DMX CONFIGURATION
If the ColorWash option is installed, please skip this section and proceed to the Control Board and Network
Connectivity sections on page 9.
Data Input
•
The DMX connections bring fixture data into the
EDGE
PDT board and optionally pass the data along to
other DMX devices.
•
Terminal blocks are provided for connecting the three discrete wires in the data cable; these are marked on
the board next to the terminals (D+, D-, and COM).
•
Optionally, the RJ45 (8P8C) connector can be used instead of the three terminals if the DMX source
supports this type of cabling. (XLR-to-RJ45 adapters are available from electronics distributors like
Newark.)
•
A DMX terminator switch is provided on the PDT board. It is set to terminated at the factory. Move this
switch to its other position if termination is not required. An indicator for the termination being active
is provided near the termination switch. DMX Installation is now complete. Disregard the
ColorWash
Installed Option
section next.
