Appendix A: Default Controller Configuration
27
Programming Mode Menu
Level
2
Level
3
Level
4
Level
5
Level
6
Notes
SP1
Process goal for PID, default goal for
oN.oF
SP2
ASbo
Setpoint 2 value can track
SP1
,
SP2
is an absolute value
dEVI
SP2
is a deviation value
ALM.1
Note:
This submenu is the same for all other Alarm configurations.
tyPE
oFF
ALM.1 is not used for display or outputs
AboV
Alarm: process value above Alarm trigger
bELo
Alarm: process value below Alarm trigger
HI.Lo.
Alarm: process value outside Alarm triggers
bANd
Alarm: process value between Alarm triggers
Ab.dV
AbSo
Absolute Mode; use
ALR.H
and
ALR.L
as triggers
d.SP1
Deviation Mode; triggers are deviations from
SP1
d.SP2
Deviation Mode; triggers are deviations from
SP2
CN.SP
Tracks the Ramp & Soak instantaneous setpoint
ALR.H
Alarm high parameter for trigger calculations
ALR.L
Alarm low parameter for trigger calculations
A.CLR
REd
Red display when Alarm is active
AMbR
Amber display when Alarm is active
dEFt
Color does not change for Alarm
HI.HI
oFF
High High / Low Low Alarm Mode turned off
Level 2 Level 3 Level 4 Level 5 Level 6 Level 7 Level 8
Notes
dSbL
Latch output error disabled
t.CAL
NoNE
Manual temperature calibration
1.PNt
Set offset, default = 0
2.PNt
R.Lo
Set range low point, default = 0
R.HI
Set range high point, default = 999.9
ICE.P
ok?
Reset 32°F/0°C reference value
dSbL
Clears the ICE.P offset value
SAVE
_____
Download current settings to USB
LoAd
_____
Upload settings from USB stick
VER.N
1.00.0
Displays firmware revision number
VER.U
ok?
ENTER downloads firmware update
F.dFt
ok?
ENTER resets to factory defaults
I.Pwd
No
No required password for INIt Mode
yES
_____
Set password for INIt Mode
P.Pwd
No
No password for PRoG Mode
yES
_____
Set password for PRoG Mode
