Gamma 8800 Els, Руководство пользователя

Страница: 23 / 28

23
Switch Action Clamp Base Adjustment
If the clamp bases slip on the turntable, the base
locking levers may need adjusted. Turn the cap
screw located on the end of the clamp base clock-
wise to tighten the clamp and counterclockwise
to loosen it. If frequent adjustment is needed, try
loosening the locking lever adjustment screw and
tighten the two screws located on the underside
of the clamp base. Re-tighten the locking lever
adjustment screw and adjust as needed.
Adjusting String Clamp Jaw Spacing
The string clamps will need minor ad-
justments according to what string type,
construction, and gauge you are using. To
adjust the gap (clamping pressure) between
the clamp jaws, insert the string through the
racquet as if you were beginning the main
strings. Clamp the strings and pull tension.
If the string slips through the jaws of the
clamp, tighten the clamp by compressing
the clamp jaws together by hand while turn-
ing the Adjustment Knob, in the clockwise
direction. If the clamp leaves impressions or
damages the string, it may be excessively
tight and should be adjusted by turning the Adjustment Knob counter clockwise to open the
gap between the jaws. The clamp jaws should be cleaned periodically to be free from dirt,
oil, and any string coating for them to grip properly. Knife sharpening stones are excellent for
removing build-up on the diamond coated surfaces and are available.
MAINTENANCE & ADJUSTMENTS
Adjustment
Knob
Switch Action Clamp Base Removal
Switch Action clamp bases can be removed
from the turntable for maintenance or clean-
ing by removing clamp stop located at the
end of the slot in the turntable. To remove the
clamp stop, remove the two screws holding
the clamp stop in place from the underside of
the turntable. Lift the clamp stop out of the
slot, slide the clamp base to the end of the
slot and lift it out. Replace the clamp base
and clamp stop in reverse order.