![background image](http://html1.mh-extra.com/html/gama/easy-spray-h/easy-spray-h_service-manual_3308459013.webp)
Easy Spray-H
Service Manual
13/48
Issue 1.9
Ref. NR-00088-ENG
http://www.gamapur.com/
The sequence for entering commands is as follows:
First we set the temperature of the ISO and POL heaters.
Next, we set the temperature of the ISO hoses.
Then we set the hose current consumption in amps.
Finally, we enter the cycle preselector setting.
If the temperature control sensor is not active, the symbol
(---)
appears on the display and the
heating switches off.
In versions with a transformer, the lower pushbutton on the
transformer switches the hose heating on and off. This
pushbutton incorporates an LED which lights up when the
heating is operating; a flashing LED indicates that the heater
is on but is not heating up.
Turn the potentiometer clockwise to increase amps, and anti-
clockwise if you wish to decrease amps. Adjustment ranges
from 0 to 50 amps.
Take the values below as an approximate reference to select
the intensity that allows reaching the requested application
temperature.
30 A
38º C 100º F
35 A
48º C 118º F
40 A
60º C 140º F
45 A
75º C 167º F
50 A
80º C 176º F
Turn the potentiometer clockwise until the screen shows the required amps for a quick pre-
heating.
NOTE:
The circuit breaker software of the transformer has a safety system to prevent
the hoses from being exposed to high temperatures during long periods of time.
If you have selected a potential over 35 amperes, after 20 minutes, the potential will
automatically regulate to 35 amperes.
This potential cannot be set above 35 amperes until the heater is disconnected from the
hoses and reconnected.
.