and a rear tamper sticker on the wall to detect a change in light when the cabinet is
removed from the wall.
• Locking the cabinet
Two cabinet keys are provided to secure the contents of the cabinet.
• Knockouts
The knockouts in the side panels of the cabinet can be carefully tapped or cut out.
Procedure
1. Disconnect the earth wires connected to the cabinet door and left inside of cabinet and
remove the door for ease of installation.
2. Remove the backplate from the cabinet by unscrewing the two nuts (centre left-hand side
of the I/O board and D8 module) and lift it out.
3. Identify and create the knockouts needed for cables and the antenna (if using the Alula
BAT-Connect, refer to separate installation note).
4. Mark the position of the six mounting holes and rear tamper detector (light pipe) on the
cabinet mounting surface.
5. Fix the rear tamper sticker to the mounting surface. The sticker must align with the light
pipe located in the back face of the cabinet.
6. Secure the cabinet to the wall, using a minimum of four securing anchors. The cabinet
must be tight and flush against the wall. This ensures the distance between the rear
tamper sticker and the controller's rear tamper detector is kept to a minimum.
7. Hook the backplate under the bolt heads on the right-hand side and align the two holes
with bolts.
8. Secure the backplate back into place with two nuts.
9. Reconnect the earth wires to the door and to the body of the cabinet.
10. If using the Alula BAT-Connect for monitoring, refer to the US Monitoring Kit installation
details.
11. An Expansion Kit is availale to increase capacity to support more doors, refer to the US
Expansion Kit installation details.
