Gallagher 3E1773, Инструкция по эксплуатации

Страница: 11 / 76

EnglishEnglish
Gallagher 3E1773 Ba ery Powered Energizer User Manual
English
11
How to Install the Fence
HOW TO INSTALL THE FENCE
1. Plan the fence line. Avoid rough, stony or steep areas if possible. For best
electric fence performance use mul -wire (at least 3 wires connected in
parallel) fencing.
2. Install end strain posts and corner posts. Ensure that all corner posts are well
installed to withstand the wire strain. Ensure the cross wire does not touch the
hot (live) wires.
3. Run out the bo om wire between the end posts.
4. Tension wires un l there is only a slight visible sag.
5. Connect all live wires in parallel at the end of each fence
sec on using Joint Clamps G6030. Use Joint Clamps G6030
to ensure ght wire connec ons. Connect any earth wires
together in parallel. Never connect hot (live) and earth
wires together.
6. Conduct the fence system under gateways, rather than overhead. Do not use
electric gates to get power across gateways. Install Lead-out Cable G6270 in a
plas c pipe (for physical protec on), 30cm (12”) deep. Turn the ends of the pipe
down to keep water out. Connect each end of the cable to the joint clamps.
G6030
Cross Bar
G6781 Strain Insulator
G6430
Cros
s Wire
Fence direc on
3m
(10 )
ALL HOT WIRE SYSTEM
Cut-out Switch
LIVE CABLE
12” (300mm) deep
Joint Clamps
HOT
HOT
HOT
EARTH WIRE RETURN SYSTEM
Joint Clamps
Cut-out Switch
LIVE CABLE
EARTH CABLE
HOT
EARTH
HOT