Galil DMC-41x3, Руководство по установке

Страница: 15 / 21

J4 - Analog 15 pin D-sub Connector (Male)
Pin # Label Description
1 AGND Analog Ground
2 AI1 Analog Input 1
3 AI3 Analog Input 3
4 AI5 Analog Input 5
5 AI7 Analog Input 7
6 AGND Analog Ground
7 -12V -12V
8 +5V +5V
9 AGND Analog Ground
10 AI2 Analog Input 2
11 AI4 Analog Input 4
12 AI6 Analog Input 6
13 AI8 Analog Input 8
14 N/C No Connect
15 +12V +12V
Communication with Galil Software
To communicate with the controller, the GalilTools communications software must first be installed.
A free version of GalilTools (GalilTools-Lite) may also be used. These software applications can be
found on the software installation CD shipped with the controller, or online at:
http://www.galilmc.com/support/software-downloads.php
Installation instructions for your operating system can be found in the GalilTools user manual.
http://www.galilmc.com/support/manuals/galiltools/introduction.html
Once the software has been installed, run GalilTools, or GalilTools-Lite and choose your controller.
USB connection
If you are using a USB connection, connect the DMC-41x3 USB port to your computer via a Male
Type A – Male Type B USB cable. The port will be identified as a new Serial port. The USB port is
designed for basic communication to the controller and the standard baud rate of the DMC-41x3
motion controller is 115200.
Ethernet connection
If you are connected to the controller via an Ethernet connection, and your network is DHCP enabled,
then the controller will automatically have an IP addressed assigned to it. If your network is not
DHCP enabled, or the connection is only between the PC and the controller, then the controller be
found with the software as no IP address assigned. The GalilTools software will allow you to assign
the controller with an IP address. See the GalilTools documentation for detailed information on using
the software to assign the controller IP address.