GAL MOVFE 2500, Механическое руководство

Страница: 10 / 29

6
Figure 4
13. Mount the tension block # 5 to the fixing strut. Put the hex screw toward the take up pulley.
14. With the door in fully opened position, install the open door stop # 9 in contact with the lower belt
Bracket # 3. Firmly secure the stop.
15. Locate the gate switch assembly # 6 underneath large pulley at closed position.
For S/O doors refer to Fig. 3. For C/P doors refer to Fig. 4.The gate switch roller # 11 on the
Sheave bracket has to engage the flipper fully.
To install the gate switch on a single piece hanger you will have to drill an 11/32” hole in the
Hanger Tighten the gate switch assembly.
16. If the keeper style clutch is being used; mount the keeper bracket # 7 to the right for R.H. or
left, for L.H. (item # 3 on Fig. 3) Secure the keeper bracket assembly.
17. With the door in fully closed position, place the clutch cam # 8 as shown in Fig. 3. Adjust the
clutch cam so that the short release bar is fully retracted.
With the door slightly open, adjust the eccentric roller on the back of the belt bracket # 3 to keep
the roller in position. Use a 5/32” Allen key and 1/2” open-end wrench. Secure the clutch
assembly.
IMPORTANT: A minimum 1/4” space is required between the roller and the inside of the clutch
Cam #8.
CENTRE PARTING
23
25
24
1/4"
RIGHT HAND SHOWN
DPM DCL
AUX DOL AUX DOL