GAL MOVFE 2500, Механическое руководство

Страница: 8 / 29

4
MECHANICAL SETUP INSTRUCTIONS
Determine the door and hanger type of the system.
I. Side Opening (S/O), left or right hand, and single-piece hanger.
II. Side Opening (S/O), left or right hand, and two-piece hanger.
III. Center parting (C/P) door and a single piece hanger.
IV. Center parting (C/P) door and two piece hanger.
1. If the header has not yet been installed; mount the fixing strut # 19 onto the header before
installing the header assembly .
Fasten the header with five ½” bolts at a distance of 9¼” from the track rolling surface.
The fixing strut length should be equal to or longer than the header width, as shown in the
2. Check the distance from the door track centerline to the face of the header. Distance should be
1¼”. If the centerline of the track is farther than 1¼” from header, you need to shim the strut
by the difference. Misalignment would cause wear and noise to the belt.
11
1/4"
Figure 1
3. Install the car door hangers, if necessary.
Fig.1
9
1/4"
HEADER PLATE & TRACK
CENTRE PARTING
Center line
Top of track
19
DPM DCL AUX DOL DCL DPM AUX DOL