GainSpan GS2200M, Руководство пользователя по оборудованию

Страница: 25 / 48

GS2200M Starter Kit Board Hardware User Guide GS2600M Starter Kit Board Hardware Overview
Starter Kit Board Software
GS2K-SKB-HW-UG-001278, Release 1.0 25
1.2 Starter Kit Board Software
The SKB comes with the GainSpan Temperature and Light Sensor (TLS) demonstration
application pre-installed. This application demonstrates using the SKB as an IoT sensor
device that measures the light level and ambient temperature and reports these
measurements to a mobile application or web browser. For more information about the TLS
application, refer to the
GainSpan Temperature and Light Sensor (TLS) Demo Application
Note.
22 VREG (J14)
Configures the power source to the GS2200M module's
internal regulator. Use 1.8V setting for ultra low power
designs. Use 3.3V for lower cost designs to eliminate
the external 1.8V regulator from the circuit.
23
Arduino Shield Connectors (J1,
J2, J3, J4)
Arduino shield connectors. The SKB can be configured
to be the host (default) or a shield. See
GS2200M SKB
Arduino Connector Pinouts, page 46 .
24 Test Points (TP4, TP5)
Bench power supply connection points. Connect a
3.3V supply for bench powering and set the power
source selection jumpers to use the bench supply as the
power source.
Note: The on-board power switch is bypassed when using a bench supply.
Use the switch on the bench supply to switch power on or off.
Table 7 GS2200M Starter Kit Board Components - SKB 1.2 (Continued)
No. Component Description
NOTE: For GS2200M hardware specifications, refer to the GainSpan GS2200M
WiFi Module Data Sheet.
NOTE: Additional software/documentation are available on the GainSpan
Support Portal website: www.gainspan.com/secure/login .
NOTE: For re-programming the module, use the gs2k_flashprogram GUI tool
and follow the steps per the GainSpan GS2000 Based Module Programming User
Guide.
NOTE: The Temperature and Light Sensor (TLS) application is supported on the
GS2200M starter kit and GS2011M evaluation board only.