Gainsborough MALVERN, Руководство пользователя

Страница: 11 / 12

11
Malvern manual version 1.0 S.D 25.4.2014
To get the most out of your Malvern bath we recommend that the unit is cleaned and maintained on a daily basis.
The chrome seat tube should be cleaned using a silicone based cleaning product (such as Mr Sheen)
Spray a small amount on the tube when the seat is fully raised and wipe with a dry soft cloth. This will avoid any
build up or soap, water or atmospherics.
The bath can be cleaned with a medical disinfectant, especially if the product is to be used with multiple users.
Do not use abrasive type cleaners. Oven cleaners, scouring powders or bleach on this product.
Code 1: Lift actuator fault : One long flash followed by 1 short flash
---------- ----- ---------- -----
Code 2: Traverse actuator fault : One long flash followed by 2 short flashes
---------- ----- ----- ---------- ----- ----
Code 3: Leg Lift actuator fault : One long flash followed by 3 short flashes
---------- ----- ----- ---------- ----- ----
Code 4: Bath lift actuators fault : One long flash followed by 4 short flashes
---------- ----- ----- ----- ----- ---------- ----- ----- ----- -----
If any of the above fault codes are indicated on the status display please contact our service department.
1. The seat will not traverse — make sure the bath is fully lowered.
2. The seat will not raise — Check that the system has mains power (green light on status display)
3. Bath will lower but not raise — Check that the system has mains power (green light on status display)
4. Flashing blue light on status display — disconnect mains power, wait 5 minutes, re apply power.
For any other issues please contact the service department.