6
Pole mounting
The optional mounting kit (No 100-02-02
81
-001) can be used to attach the Com-
mander GSM to round poles with diameters between 100mm and 200mm, or to
square/rectangular section uprights with surface widths between 100mm and
150mm. For flat mounting on surfaces greater than 150mm across, use the wall or
desk mounting methods, as appropriate.
Note: Banding straps (large scale worm-drive clamps) are not included in this kit
and must be obtained separately. For details of where banding can be obtained,
please refer to GAI-Tronics.
1 Use a 5mm hex key to remove the three bolts that secure the front section of
the enclosure to the rear section. Carefully separate the two sections. Beware
of cable connections between the sections.
2 If fitted, remove the four rubber feet from the mounting holes of the rear casing.
3 Attach the pole mounting clamps (from the optional mounting kit) to the upper
and lower holes of the rear casing. Use the M6 x 25 screws supplied in the kit
and tighten them to a maximum torque of 4.5Nm.
Mounting clamp
Banding strap
Rear casing
Important: Do not create
any further holes in the
enclosure; to do so will
significantly reduce the
environmental protection
offered to the internal
components and will
invalidate the warranty.