9
4 Now please refer to the
SIM insertion and connections
section on page 12.
Rotate 180 degrees
Cable
glands
at rear
Desk mounting
When mounting on horizontal surfaces (greater than 150 x 280mm) use this
method to provide a ‘rake’ for convenient operation and to ensure that the cable
entries are located at the rear.
1 Use a 5mm hex key to remove the three bolts that secure the front section of
the enclosure to the rear section. Carefully separate the two sections. Beware
of cable connections between the sections.
2 Ensure that the four rubber feet are fitted to the underside of the rear casing.
3 In the rear casing, reposition the internal battery pack as detailed in the section
Internal battery pack positioning
on pages 10 and 11.
4 Taking care not to trap any wires, rotate the front casing through 180° to
produce the ‘rake’ required for convenient desk operation.