5
Mounting the enclosure
This section covers the three main ways in which the Commander GSM enclosure
can be positioned:
• Pole mounted - see page 6
• Wall mounted - see page 8
• Desk mounted - see page 9
Preparing the enclosure
Before mounting the Commander GSM, check the cable routing and require-
ments. Fit the appropriate gland to the case as follows:
1 Remove the RED blanking plug, leaving the other (usually BLACK) in place.
Only fit a second gland if a separate cable is required to the phone (for exam-
ple when using an external antenna, or external sounder options).
2 Select the appropriate sized gland:
• Use the smaller gland for cables diameters 4 to 7mm.
• Use the larger gland for cable diameters 8 to 13mm.
3 From the outside of the case, carefully insert the selected gland into the
threaded cable entry hole.
Cable entry hole
in base of rear
casing
Gland
body
Gland
nut
Sealing
washer
IMPORTANT: Double check that the threads of the gland and the hole are cor
-
rectly engaged and are not cross threaded. Hand tighten them at first. If there
is any great resistance to tightening, STOP and check the threads. Only use a
spanner to tighten the gland when you are certain of correct alignment. Take
care not to overtighten.
Tighten the gland so that its sealing washer is compressed against the enclo-
sure surface.
4 Proceed with chosen mounting method: Pole, wall or desk.