21
ENGLISH
The rinsing procedure may:
A
be stopped by pressing the "
" (15) or (13) button.
B
be deactivated by pressing the "
" button (15) while
the "
" light (14) is blinking or steady on; in this case the
"
" light (16) turns off.
Note: if the rinsing procedure is deactivated, it
can be reactivated only by pressing the "
"
button.
6 Energy Saving
The machine is designed for energy saving.
After 9 minutes of inactivity, the machine turns off in order to
save energy and respect nature.
Press the ON/OFF "
" button (11) to operate the machine.
7 Coffee Brewing
Warning! During coffee brewing it is forbidden
to remove the pressurized filter holder by
manually turning it from right to left. Danger of burns!
• During this operation, the "
" light (14) is blinking; this
is to be considered as a standard and not a faulty operating
mode.
• Before using the machine, make sure that there is enough
water in the machine tank.
Note: if the steam knob is opened by mistake
during the warm-up phase, the " " light
(20) starts blinking. Close the knob and wait until the
machine is ready.
If coffee is NOT brewed after pressing the brew
button "
" (13), press the brew button "
"
(13) again and check the "Troubleshooting" table before
removing the filter holder.
Ensure the machine is ready before brewing coffee. The
machine is ready when the "
" light (14) is steady on.
7.1 Filter Holder Warm-Up
If the "rinse" function is not activated and/or the filter holder is
to be warmed-up manually, do as follows:
•
13
Insert the pressurized filter holder into the brew unit
(4) from the bottom.
•
14
Turn the pressurized filter holder from left to right un-
til it locks into place. Release the pressurized filter holder
grip. The handle will turn slightly to the left. This move-
ment guarantees optimum filter holder performance.
•
17
Preheat the pressurized filter holder by pressing the
(13) button; some water will flow out of the pressurized
filter holder (this operation is necessary only for the first
coffee).
• After 50 cc of water have been dispensed, press the (13)
button again to stop the dispensing procedure.
•
19
Remove the pressurized filter holder by turning it from
right to left and then drain the remaining water.
Place a container under the dispensing spout.
Now you can go on with the coffee brewing procedures
described in the following sections.
7.2 Using Ground Coffee
•
7
Insert the filter (23) in the pressurized filter holder
(21); at first use, the filter is already on. With the special
filter (23) provided there is no need to change the filter to
make one or two coffee(s).
•
8
Add 1-1.5 measuring scoop(s) for a single coffee and 2
measuring scoops for a double coffee. Remove any coffee
residues from the rim of the pressurized filter holder.
Note: do not press the coffee, since the filter
holder is provided with an optimized system
for original espresso brewing.
•
13
Insert the filter holder (21) into the brew unit (4) from
the bottom.
•
14
Turn the pressurized filter holder from left to right un-
til it locks into place. Release the pressurized filter holder
grip. The handle will turn slightly to the left. This move-
ment guarantees optimum filter holder performance.
•
16
Take
1 or 2 preheated cups
and place them un-
der the pressurized filter holder. Make sure that they are
placed correctly under the coffee brewing nozzles.
•
17
Press the "
" button (13).
•
18
When the desired quantity of coffee has been brewed,
press the "
" button (13) again to stop the brewing pro-
cedure. Wait for a few seconds after brewing, then remove
the cups of coffee.
•
19
After brewing, wait until the "
" coffee light (14)
stops blinking, then remove the pressurized filter holder
by turning it from right to left and empty the remaining
coffee grounds.
Note: a small quantity of water remains in
the pressurized filter holder. This has to be
considered as absolutely normal and is due to the filter
holder characteristics.
4219-450-03711 MANUAL GAG. CAREZZA IT-EN-DE-FR-ES-PT.indd 21
03/12/2018 11:32:13
