AFR200 Series, Product User Guide
This document is subject to change without notice.
Caution: None of GAC products are flight certified controls including this item
Copyright © 2010, Governors America Corp., All Rights Reserved
26
PUG4144 D
Mixer on ATB with Regulator Installed
Naturally-Aspirated Application Shown
The following figure shows the dimensions of the gas pressure regulator for the purpose of determining a suitable
mounting or placement location. Refer to the component selection section
to determine the regulator choice if you
purchased one from GAC.
Zero Pressure Gas Regulator Dimensions
Dimensions shown as in. [mm]
6.4.1 Application Considerations
•
The installation must comply with all local and government regulations and safety codes.
•
The gas regulator MUST be installed with the adjustment post pointing upward and the regulator body
extended horizontally in order to guarantee consistent operation.
•
It is recommended that the regulator is installed as close to the air-fuel control valve / mixer as the
installation will allow. This helps the regulator to provide the best performance in governing the inlet gas
supply pressure and fuel volume.
•
Regulator feedback will automatically adjust supply pressure and volume based upon restrictions in
the intake tract such as a clogged air filter.
•
Use the dimensions provided in the following figure
to determine a suitable location that will not be
obstructed or prone to damage by other components.
Reference Port
Fuel Inlet
Pressure
Regulator
Air-fuel Mixer Assembly
ATB
Interconnect Fittings
Adjustment
Post
