G-TEL Enterprises 2150 Smart Bell Style, Инструкция по эксплуатации

Страница: 8 / 11

8
A PROGRAMMING INSTRUCTIONS STR ION
Entering the Program Mode
All program entries must be done in the program mode, using the keypad of the
payphone.
When programming, one ‘beep’ represents a completed entry. Three ‘beeps’ represents an
error. To start an entry over, press the # key & wait for three ‘beeps’ & then re-try the entry. All program
entries can be done in one session in no specific order.
1. Open the upper housing of the payphone
,
(see Separating the Upper & Lower Housing on page 6.)
2. Ensure that the dial / hookswitch connector (JF) & the Ni-Cad battery (JD) are both
connected.
3. Push & hold the black program button (PB1) on the circuit board.
4. Take the handset off-hook
,
(while program button is held down.)
5. Listen for a single ‘beep’.
6. Release the program button,
(after the single ‘beep’ is heard.)