G-TEL Enterprises 2150 Smart Bell Style, Инструкция по эксплуатации

Страница: 5 / 11

5
MOUNTING INSTRUCTIONS
Mounting the Backboard or Enclosure
OUTDOOR INSTALLATION
If the payphone is to be installed outdoors, you must use an outdoor pedestal / enclosure
to mount the payphone and to prevent weather deterioration. Outdoor pedestals can be
mounted using concrete anchors. Outdoor wall-peds can be mounted using toggle bolts.
The telephone cable should be routed to the pedestal using EMT conduit. Once the
pedestal & enclosure is mounted, follow the instructions starting on page 4 to mount the
payphone to the pedestal & enclosure.
INDOOR INSTALLATION
λ
It is recommended to use ¼” Toggle Bolts (with washers) to secure the backboard or
enclosure to the wall. The length of the toggle bolt depends on the thickness of the wall. Anchor
Screws may be used as an alternative to Toggle Bolts.
1. Ensure that the wall that the backboard or enclosure is to install to is flat & level.
2. The top height of the backboard or enclosure should be determined by the following:
Standard Height = 58” from floor Wheelchair Accessible = 51” from floor
3. Place the backboard or enclosure against the wall at the desired height & mark the Line
Wire Entrance Hole & Mounting Holes to be used, (the backboard or enclosure offers
10 mounting holes, although not all 10 must be used.) Use the diagram below to
ensure the backboard or enclosure is not upside down or backwards.
4. Drill through the marked holes on the wall using a drill bit similar to the size of the
toggles being used.
5. Route the telephone line cable through the Line Wire Entrance Hole.
6. Insert each toggle bolt & washer through the mounting holes being used on the
backboard or enclosure.
7. Secure the backboard or enclosure against the wall through the pre-drilled holes &
tighten each toggle bolt.