G.T.Power A620, Руководство по эксплуатации

Страница: 15 / 29

- 12 -
This shows the number of cells you set up and the processor detects. ' R:' shows the number of
cells found by the charger and ' S:' is the number of cells selected by you at the previous screen.
If both numbers are identical you can start charging by press Start/Enter button. If not, press Batt
Type/Stop button to go back to previous screen. Then carefully check the number of cells of the
battery pack to charge again.
The screen shows the present situation during charge process. To stop charging press Batt Type/
Stop key once.
7.2 Charging Lithium battery at balance mode
This is for balancing the voltages of Lithium batteries of the battery park to be charged. The battery pack to be charged should
be connected to the suitable balance port at the right side of the charger. And also, you need to connect the battery output plug to
the output of charger.
In this mode, the charging process will be different from ordinary charging mode. The internal processor of the charger will monitor
the voltages of each cell of the battery pack and controls charging current that is feeding to each cell to normalise the voltage.
The value on the left side of second line sets a charge current and the value on the right side of
second line sets the voltage of the battery pack.
After setting the current and voltage press
Start/ Enter key for more than 3 seconds to start the
process.
(Charge current:0.1~20.0A, Volatge:1~6 series)
This shows the number of cells you set up and the processor detects.' R: ' shows the number of
cells found by the charger and ' S:' is the number of cells selected by you at the previous screen. If
both numbers are identical you can start charging by press
Start /Enter button. If not, press Batt
type/Stop button to go back to previous screen. Then carefully check the number of cells of the
battery pack to charge again.
Balance