G.T.Power A620, Руководство по эксплуатации

Страница: 13 / 29

- 10 -
An optional feature using temperature probe contacting the surface of battery, the temperature
cut-off can be on or off. If it is on, set the maximum temperature at which the charger should allow
battery to reach during charge, Once a battery reaches this temperature during charge, the process
will be terminated to protect the battery.
The battery is on the cyclic process of charge and discharge can often become warm after charge
or discharge period. The program can insert a time delay to occur after each charge and discharge
process to allow the battery adequate time to cool down before being subjected to the next
process. The value ranges from 1 to 60 minutes.
You can set the trickle charge mode on or off.If it is on, the charge will automatically supply the
trickle charge current to achieve the full charge without overheating the battery after fast charge
has been terminated.
When you start a charge process, the integral safety timer automatically starts running at the
same time. This is programmed to prevent overcharge the battery if it proves to be faulty, or if the
termination circuit cannot detect the battery full. The value for the safety timer should be generous
enough to allow a full charge of the battery .
This program sets the maximum charge capacity that will be supplied to the battery during charge.
If the delta-pack voltage is not detected nor the safety timer expired by any reason, this feature will
automatically stop the process at the selected capacity value.
The beep sounds at every time pressing the buttons to confir m your action. The beep or melody
sounded at various times during operation to alert different mode changes. These audible sounds
can be on or off.