Arm Via Text Message
To set the alarm to ON you will need to send the text message
#
ALARM
=
ON
#
This will activate the alarm
#
ALARM
=
OFF
#
This will deactivate the alarm
It is important to remember that once the alarm has been triggered you will need to reset
the alarm by sending the text command
#
ALARM
=
ON
#
to reactivate the alarm or activate
it using the key fob.
Arm Via Key Fob
The key fob works best when used with the siren provided as you will get the audible alert
whenever you arm or disarm the alarm.
Press button A on the key fob
Arms the alarm and siren will beep twice
Press button B on the key fob
Disarms the alarm and the siren will beep twice
IMPORTANT - PLEASE READ
Again it is important to remember that when the alarm has been triggered you will need to
reset the alarm using either the text command (above) or by using the fey fob.
In auto mode, the key fob and text message are disabled, the alarm is always “Active”.
After the alarm is triggered it will automatically reset to active after 20 seconds
In the event of a power loss the unit will remember if it was armed when power is restored.
How to use the Relay Output
The relay has been programmed to trigger the siren for 60 seconds in the event of an
alarm activation. Once the text message and call has been received you can stop the siren
sounding by pressing B on the key fob.
If you do not require the siren to sound in the event of an alarm activation but require it so
that you hear the key fob activation you can turn the siren OFF by Dipswitch 1.
Dipswitch 1 ON
Siren is turned ON
Dipswitch 1 OFF
Siren turned OFF
If you require the ability for the relay to be independently activated like older versions of
this alarm, please contact us on the details below.
www.gsm-activate.co.uk
- 01273462380 - [email protected]
Page 6
