8
. POWER SUPPLY AND SIGNAL CONNECTION
1. Power supply
Use the professional plug to connect the projector and main power
supply. Please pay attention to the voltage, frequency the same as the
mentioned on the projector. Suggest each light has separately switched of
the power supply so that could turn on or turn off each projector
desultorily.
2. Signal connection
Please use the round 3-pin XLR plugs &sockets offered by menu
facture to connect the first projector's output to the second projector'
input and connect the second projector's output to the third projector's
input. And in the same way for the rest, eventually connect the last
projector's output, all the projectors are together as the following figure.
The projectors’ control signal output or input by using the 3-pin XLR
pug and socket. If need to long then the communication cable, please
make sure the both side of 3-pin plug is one to one. (one to one, two to
two, three to three). Otherwise, the communication cable will be
interrupted. The communicate cable is 2-pin shielded cable 75
Ω
Resistance with each core is at least a 0.5mm diameter. (Caution: All the
inside leading wire of 3-pin XLR plug couldn't touch each other or
plinth).
8
Содержание ARCH 90 90X3W
