P a g e . 15
Connect washer adaptor
with
welding gun and tighten,
Install washer.
Remark
:
1
、
Setting amperage too high or time too long can cause workpiece surface (vehicle
body)damage .
Please weld other workpieces for practice before actual operations
.
2
、
Setting correct amperage and time according to the workpiece thickness
.
3
、
Continuing another operation is available after this procedure finished .if not, please
shut off the main power supply and switch
off the unit
.
F017+F011+F020
a
、
Washer Welding
Set correct time
.
Set correct amperage.
Approximately a 90°angle to the
dent
.
Put on pressure and
press trigger
.
%
Connect negative outside wire
to a clean,paint-free location
on metal workpiece,as close to
welding area as possible.
Remove welding gun
.
Hook the
washer with pull hammer
.
Slide
the hammer to oppositedirection
to pull out the dent .
7 . S t e el D ent P ulle r A p pli c ati o n
