Remark
:
1
、
Setting amperage too high or time too long can cause workpiece surface (vehicle
body)damage .
Please weld other workpieces for practice before actual operations
.
2
、
Setting correct amperage and time according to the workpiece thickness
.
3
、
According
to
actual
conditions
to
select
a
suitable
puller
for
repairing
4
、
The
nut
of
the
puller
is
to
adjust
the
up
and
down
moving
range
of
the
main
axle
5
、
Continuing another operation is available after this procedure finished .If not ,please
shut off the main power supply and switch
off the unit.
Weld the studs to the dent area of
car body. Put the corresponding
pulling screw on the studs and
tighten up.
Choose crossbar lifter: Make sure the
crossbar lifter with pulling hook is fixed on
the car body. Connect the pulling hook to the
pulling screw. Adjust the adjusting screw of
the crossbar lifter. Squeeze the lever to pull
out the dent.
Choose crossbar lifter: Make sure the
crossbar lifter with pulling hook is fixed on
the car body. Connect the pulling hook to
the pulling screw. Adjust the adjusting
screw of the crossbar lifter. Rotate the
lever to pull out the dent.
Choose pulling hammer: Connect
corresponding pulling hook to the pulling
screw. Slide the hammer to opposite
direction to pull out the dent.
A variety of pulling hooks are available to fit crossbar lifter and pulling hammer.
P a g e . 1 3
5 . P u l li n g H am me r A pp li ca ti on
