FXA FXA501575750, Инструкция по эксплуатации

Страница: 9 / 44

9
tool, taking into account the working conditions
and the work to be performed. Use of the power
tool for operations different from intended could
result in a hazardous situation.
5) SERVICE
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
COMPONENTS & CONTROLS (FIG.1)
UNPACKING
This packaging contains sharp objects. Take care
when unpacking. Remove the machine, together with
the accessories supplied, from the packaging. Check
carefully to ensure that the machine is in good
condition and account for all the accessories listed in
this manual. Also make sure that all the accessories
are complete. If any parts are found to be missing, the
machine and its accessories should be returned
together in their original packaging to the retailer. Do
not throw the packaging away, keep it safe
throughout the guarantee period, then recycle if
possible, otherwise dispose of it by the proper means.
Do not let children play with empty plastic bags due
to the risk of suffocation.
LOCATION & GROUNDING
Before using this generator it must be prepared
correctly before use. Locate the generator on firm
level ground away from buildings or other structures
ensuring that the exhaust is not obstructed.
It is advisable to properly earth-ground your generator
before starting using a wire and a small earth stake.
Note: The wire and earth stake are not supplied with
the unit.
Earth spike and cable can be purchased at your local
camping supplies, or alternatively an earth spike can
be made, and it is suggested you get advice from a
registered electrical trades person. To make a spike
use a copper tube or copper rod 12mm diameter, a
minimum length of 200mm and with an M6 machine
screw one end. The cable used should be a maximum
length of 1 metre and a minimum of 1.0mm
2 to carry a
10amp load. The cable should be attached to the
generator at the earth point (Fig 2) and to the spike
between a flat washer and the copper with a lock
washer under the head of the M6 Machine screw in a
similar fashion to the earth point screw on the
generator.
When placing the spike into the ground the generator
must not be running and it is suggested that the spike
is pushed into the ground by at least 100mm so that it
is firm and a litre of water poured around it to ensure
good earth continuity.
CHECKING THE OIL
The generator is supplied without oil and must be
filled before first use, failure to do so will invalidate
your guarantee. Loosen the cover screws and remove
the maintenance cover.
Remove the oil filler cap and wipe the dipstick clean,
Fig 3.
Check the oil level by inserting the dipstick into the
filler neck without screwing it in. If the level is low, fill
to the top of the oil filler neck with the recommended
oil.
Use high-detergent, premium quality 4-stroke engine
oil SAE 10W-30.
Warning! Non-detergent and 2-stroke engine oils will
damage the engine and are not recommended.
1. Engine ON/OFF switch
2. Economy control switch
3. Fuel ON/OFF tap
4. Air filter and oil filler maintenance cover
5. Choke lever
6. AC socket (250v)
7. Ground (earth) terminal
8. Recoil starter
9. DC socket
10. DC circuit breaker
11. Pilot light (Output)
12. Overload indicator light
13. Low Oil warning light
14. Fuel filler cap
15. Fuel tank vent tap
16. Spark plug maintenance cover
17. Exhaust
18. DC charging leads
19. Screwdriver
20. Spark plug spanner
21. Primer bulb
WARNING
CAUTION
WARNING