FLATLINE VAN CO • [email protected] • 888-667-5576
7.
WHILE SOMEONE HELPS TO HOLD HINGE BACKING PLATES AND HARDWARE
IN PLACE, FIRST INSERT THE
3/8-16 X 2.25 HEX DRIVE BUTTON HEAD SCREW
AND
3/8 SCREW FLAT WASHER
THROUGH THE 3RD MOUNT OF THE TIRE
CARRIER AND INTO THE
DOOR MOUNTING BOSS
AS SHOWN IN
FIGURE 5
.
THEN FIT THE TIRE CARRIER ON TO THE PROTRUDING HARDWARE ON THE
HINGES OF THE VAN AND SECURE WITH (4)
3/8-16 FLANGED NYLON INSERT
LOCKNUTS
. LEAVE THESE A LITTLE LOOSE TO ALLOW MOVEMENT OF THE
TIRE CARRIER FOR ALIGNMENT.
NOTE-
THIS STEP IS TRICKY AND REQUIRES A BIT OF JUGGLING
BETWEEN THE TIRE CARRIER FRAME AND REQUIRED HARDWARE.
8
INSERT THIS HARDWARE FIRST
FIGURE 5
