FLATLINE VAN CO • [email protected] • 888-667-5576
6
3.
NOW YOU CAN BEGIN ASSEMBLING THE TIRE CARRIER. ATTACH THE WHEEL
BRACKET TO THE TIRE CARRIER FRAME AS SHOWN IN
FIGURE 3
USING
THE (4)
1/2-13 X 1.5 SQUARE NECK CARRIAGE BOLTS
, (4)
1/2 SCREW FLAT
WASHERS
, AND (4)
1/2-13 NYLON INSERT LOCKNUTS
. ENSURE THAT THE (2)
BACKER PLATES
ARE INSTALLED BENEATH THE CARRIAGE BOLTS AS
SHOWN IN
FIGURE 3
. TIGHTEN THIS DOWN.
NOTE-
4.
OPTIONAL STEP
- SINCE WE PROVIDE LOCKING LUG NUTS, YOU DO NOT
NEED TO INSTALL THE LOCK ROD UNLESS YOU WANT THE EXTRA
PROTECTION. LEAVING IT UNINSTALLED PROVIDES A CLEAN LOOK IF YOU
HAVE COOL CENTER CAPS FOR YOUR WHEELS. IT CAN ACCEPT VARIOUS
LOCKS, BUT OUR FAVORITE IS A TRADITIONAL HITCH LOCK.
TO INSTALL
- INSERT INTO THE WHEEL BRACKET AS SHOWN BELOW AND
FASTEN USING THE (2)
3/8-16 X 1 HEX HEAD SCREW
, AND (2)
3/8 SCREW
FLAT WASHER
. THE DEPTH IS ADJUSTABLE TO SUIT YOUR SPECIFIC WHEEL
SETUP. ENSURE IT STICKS OUT ENOUGH FOR THE LOCK TO HAVE
CLEARANCE WITH YOUR WHEEL INSTALLED.
FIGURE 3
