00029992.DOC, Version 1.3
44/90
No DMX status
With the function
"No DMX status"
, you can set different modes if there is no DMX-signal.
• Select
"Initial, Hold, Auto or Music"
by pressing Up or Down.
• Press the Enter-button, the display shows “ON” or “OFF”.
• Press Up or Down to select “ON” if you wish to enable this function or “OFF” if you don’t.
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
Initial
With this function, you can close the shutter and set the device to center position if there is no DMX-signal.
This mode equals the settings
Auto = OFF
and
Music = OFF
.
Hold
With this function, the device remains in the last received DMX-program if there is no DMX-signal.
Auto
With the function
“Auto”
, you can set the device to auto run if there is no DMX-signal.
Music
With the function
“Music”
, you can set the device to sound-controlled program-run if there is no DMX-signal.
PAN Reverse
With this function you can reverse the Pan-movement.
Fine resolution
With this function you can switch the device from 16 bit to 8 bit resolution.
• Select
“Fine resolution”
by pressing Up or Down.
• Press the Enter-button, the display shows “ON” or “OFF”.
• Press Up or Down to select “ON” in order to set 16 bit, or “OFF” in order to set 8 bit. The channel PAN Fine
will be disabled.
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
Adjust PAN speed
With this function you can define the PAN speed. You can select one of 4 different modes.
Mic sensitivity
With this function, you can select the desired microphone sensitivity between 0 % and 99 %.
• Select
“Mic sensitivity”
by pressing Up or Down.
• Press the Enter-button, the display shows “M-70”.
• Press Up or Down to select the desired sensitivity.
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
Display close time
With this function you can shut off the LED display after 1 to 59 minutes.
Initial effect
With this function, you can adjust with which value the respective channels will start.
Reset function
With this function you can reset the device via the Control Board. You can select the different Reset-
functions by pressing Up or Down.
Restore factory settings
With this function you can restore the factory settings of the device. All settings will be set back to the default
values (shaded). Any edited scenes will be lost.
