LED number. LEDs are to be visually checked. tester will report fault if it finds shorted
points.
Board Test : check Board facilitates making a rig / fixture and also to check fixture. When
Ground i.e. black terminal at the backside is touched at an I/O point, tester will display that
point number. All 128 points including pull points can be analysed.
3 : Operation :
3.1 : Front and Back panels:
Back Panel : Mains input socket with fuse and spare fuse, Mains power on switch, Relay
output terminal strip, tone and volume control for buzzer.
Use keyboard on front panel for functions as required. Refer to attached diagramof keypad
menus for detailed keyboard operation.
Relay : Relay will be normally off and will be on for @3 seconds on Pass. Relay output is
provided on back side on a terminal strip. Pole, NO and NC are all available for use.
Black terminal i.e. ground is to be used for board checking mode.
Connect power cord, provided with tester, which is similar to PC mains cord, to the tester
at socket provided on the back panel.
Switch on power using power on switch.
3.2 : Displayed messages, their meanings and keys to be used. :
FUTURA : Power on messaage
VER 1_2 : firmware version number.
COMPONENT NAME XX : Currently selected component name and number XX.
CHECK HARNESS? : If complete harness is to be checked after assembly.
START ASSEMBLY? : Start assembly?
SETUP? : Want to change settings? : ‘Up / down’ next menu, ‘Enter’ displays
O xx yy: Tester displays fault that xx and yy are open.
S xx yy: Tester displays fault that xx and yy are shorted.
PASS nnn : When assembly is completed and found correct and pass count nnn.
REMOVE ASSEMBLY : When assembly is completed and pass is indicate, tester
prompts to remove the present assembly.
CHECK HARNESS? : Asks if complete harness is to be checked after completing
assembly.
3.3 Power on:
