FUTABA SkyLeaf Leader, Инструкция по эксплуатации

Страница: 14 / 20

9
Main gear
Mount the T-nut on the bottom of the main gear. Drill a small hole with a drill so that the nail bites as the
material is hard. Then fix T-nut with epoxy glue.
Assemble the wheel and the wheel pants. Make sure the wheels are located in the center of the wheel pants
with the supplied wood washers.
Insert the main gear in the fuselage and fix with the M3 screw. Expand it because the gear insertion hole of
the fuselage is narrow.
Pay attention to the lengths of the front and rear
screws.
Cooling air vent
Be sure to open the air vent on the lower side of the
rear part of the fuselage for cooling of the motor
unit, ESC, etc. There is a guide at the end of this
manual, so use it. Adjust the hard balsa wood of
about 5 mm x 10 mm x 230 mm for reinforcement
inside the center of the outlet after opening.
Installation of Canopy stopper
Produce the canopy stopper with the attached carbon rod. Reinforce the inner side of the fuselage of the
mounting part with balsa wood like
#45 . Put the carbon rod in the center. Adhere the center. Adhere plastic
balls to both ends of the carbon rod.
42 43
45 46
44
41