Fusion3 Design F306 Generation I, Руководство по эксплуатации

Страница: 49 / 60

49
Checking for Damage
Before powering your F306 up for the first time, thoroughly inspect it for damage. This section will cover the major
things to look for, but keep an eye out for anything that looks abnormal anywhere on the machine. These sections
should be done in the order they are listed below.
If anything does not behave as described, please contact support to resolve the problem BEFORE powering up
your system.
Drive Cable Tension
Refer to Section 7.2.
XY Axes Motion
After you have checked the XY drive cables, you can move the X and Y axes through their full range of motion by
hand to check that everything moves smoothly. Gently grasp the top of the X carriage as shown in section 4.2 and
slowly move it through its entire range of motion in X and Y. You should feel little or no change in resistance or
binding as you move the carriage.
IMPORTANT : Since we are moving the axes while the machine is off, it is extremely important that this step be
done very slowly to avoid damaging the electronics!
X Crossbar Square
Refer to Section 7.3.
Check Print Bed
Check that the glass print surface is correctly captured under the corner clips and that the springs under the bed
are correctly seated. Make sure the gap between the glass and the substrate is roughly the same at each corner.
Figure 51: Bed corner clips should look like this
Install LCD Unit
The LCD unit is shipped detached from the printer to prevent it from being damaged during shipping. Attaching it
to the F306 is done with 2 bolts and 2 ribbon cables.
Remove the LCD unit from its anti-static bag in the small cardboard box.