3. SETTING UP THE EQUIPMENT
3-7
Menu Initial Setup (Fuel)
Manu Initial Setup (Use Fuel Tank for calculations)
Menu Initial Setup (Data Acquisition)
Menu Initial Setup (SC-30 Setup)
Menu Initial Setup (Calibration)
Menu Item
Description
Options (setting range)
[Number of Tank]
Select the number of fuel tanks on your
boat.
[1], [2], [3], [4]
[NickName Tank 1 to 4] Change the nickname for fuel tank 1 to 4.
Menu Item
Description
Options (setting range)
[Tank 1 to 4]
Select the tanks to calculate the fuel con-
sumption.
[ON], [OFF]
Menu Item
Description
Options (setting range)
[GP330B WAAS Mode] Select [ON] to use the WAAS mode for the
corresponding GPS antenna.
[ON], [OFF]
[WS200 WAAS Mode]
[Data Source]
Select the source for each data to input to the system. If two or more
sources are connected for a data, select one using the pull-down dialog
box. The Furuno products are shown at the upper part of the list.
[Sensor List]
Show the information for sensors connected to your equipment.
Also, you can set “Nickname” for them here.
[PGN Output]
Select [ON] for the PGNs (Parameter Group Number, CAN bus
(NMEA2000) message) to output from the CAN bus port.
[Sky View]
Show the condition of GPS and GEO (WAAS) satellites.
Number, bearing and elevation angle of all GPS and GEO satellites
(if applicable) in view of your receiver appear.
Menu item
Description
Options (setting range)
[WAAS Mode]
Select [ON] to use the WAAS mode.
[Heading Offset]
Enter the offset value for heading.
-180° to +180°
[Pitch Offset]
Enter the offset value for pitching.
-180° to +180°
[Roll Offset]
Enter the offset value for rolling.
-180° to +180°
Menu item
Description
Options (setting range)
[Heading]
Offset heading data.
-180.0° to +180.0°
[Speed Through Water] Calibrate speed data. Enter amount in per-
centage.
-50% to +50%
[Wind Speed]
Offset wind speed data. Enter amount in
percentage.
-50% to 50%
[Wind Angle]
Offset wind angle data.
-180° to +180°
[Sea Surface Tempera-
ture]
Offset sea surface temperature data.
-10°C to +10 °C
Содержание TZTBB
Страница 2: ...Installation Manual This page is intentionally left blank ...
Страница 22: ...2 WIRING 2 14 This page is intentionally left blank ...
Страница 40: ...25 Dec 2012 Y NISHIYAMA D 1 ...
Страница 41: ...21 Dec 2012 Y NISHIYAMA D 2 ...