Furuno TZTBB, Руководство по установке

Страница: 33 / 44

3. SETTING UP THE EQUIPMENT
3-11
3.4 How to Set up the Sounder
If you have a sounder (BBDS or DFF series), set up the sounder as shown in this sec-
tion. Drag the main menu to select [Sounder]. You can confirm the actual sounder dis-
play on the left-hand side of the screen while setting up.
Drag the [Menu Sounder] sub menus to select [Sounder Initial Setup].
Motion sensor setup (requires Satellite Compass SC-30/50/110)
If the satellite compass SC-30/50/110 is connected, set the distance between the an-
tenna unit (or sensor) of the satellite compass and transducer (high and low if connect-
ed), on the [Motion Sensor] sub menu, referring to the descriptions below. Tap
[Transducer Setup] and the [Motion Sensor] sub menu appears benease the [Trans-
ducer Setup] menu.
• Motion Sensor Type: Select [SC30] or [SC50-SC110] depending on the sensor
connected.
• Motion Sensor Antenna Position Bow/Stern HF (LF): Set the distance from the
antenna unit to the transducer in the bow-stern direction.
• Motion Sensor Antenna Position Up/Down HF (LF): Set the distance from the
transducer to the antenna unit in the vertical direction.
• Motion Sensor Antenna Port/Starboard HF (LF): Set the distance from the an-
tenna unit to the transducer in the port-starboard direction. If the transducer is locat-
ed on the starboard side, set a positive value.
Menu item Description
Options
(setting range)
[Zero line Rejection] Turn off the zero line (transmission line) to erase it and
see fish echoes near the surface. The width of the line
changes with the transducer used and installation char-
acteristics. If the width of the line is 1.4 m or more, select
[ON]. [ON], [OFF]
[Zero line Range] When [ON] is selected at [Zero line Rejection], set the ef-
fective area. 1.4 to 2.5 m
[Transducer Draft] Set the distance between the transducer and the draft
line to show the distance from the sea surface. 0.0 to 99.9 ft
[Salt Water] Select [ON] if the equipment is to be used in salt water. [ON], [OFF]
[Fish Finder Source] Select the sounder used, among DFF1, DFF3, DFF1-UHD, BBDS1 and
FCV-1150.
[Transducer Setup] Select the method to setup the transducer, manually or
by selecting the model number.
Manual: Enter high/low frequencies and TX power.
Model Number: Select the type of the transducer con-
nected.
[Manual],
[Model Number]
SC-30/50/110
Bow/Stern for HF
Port/Starboard for HF
Port/Starboard for LF
Bow/Stern for LF
High
Low
Up/Down