Furuno NAVpilot-700, Руководство по установке

Страница: 3 / 100

i
WARNING WARNING
Turn off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Use the proper power cable.
Use JIS type DPY-2.5 or the equivalent.
Other types can cause fire.
Confirm that no one is near the rudder
when bleeding air from oil cylinder.
The rudder may move unexpectedly,
possibly causing bodily injury.
When connecting a geomagnetism
detection type heading sensor,
correct magnetic field deviation.
If an autopilot is used without the compen-
sation, unexpected course change may
occur.
Set REMOTE CONTROLLER 1/2 on
SYSTEM SETUP menu properly accord-
ing to remote controller connected.
If not done properly, malfunction may
occur. Especially, take care when
setting the NFU-type remote controller.
CAUTION CAUTION
Control
Unit
Standard Steering
compass compass
0.35 m 0.30 m
Confirm that the power supply voltage
is compatible with the voltage rating
of the equipment.
Connection to the wrong power supply
can cause fire or damage the equipment.
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Separate the reversible pump at least one
meter from communications equipment,
communications antenna and communi-
cations cabling to prevent interference.
Processor Unit
FAP-7002
0.45 m 0.30 m
Remote
controllers
0.30 m 0.30 m
FAP-7001
FAP-7011 0.35 m 0.30 m
FAP-7021 0.35 m 0.30 m
SAFETY INSTRUCTIONS
WARNING
Indicates a condition that can cause death or serious injury if
not avoided.
CAUTION
Indicates a condition that can cause minor or moderate injury if
not avoided.
Warning, Caution Mandatory Action
Prohibitive Action
Please read these safety instructions before you install the equipment.